I soldered this board right here
which was quite unhygienic..shit loads of wires and I had to take out the 328 DIL attach it to arduino then program it or make changes then put it back on the soldered circuit..a lot of mess.
then, I tried this at home
which did work quite well but the problem was pcb designed by me itself. I had a single layer non-printed circuit board so single layer design which I made, being an amateur at this,, was a fail. You can see copper passing between two consecutive connections of atmega 328, which makes it difficult to solder and possibilities for unwanted connections. I tried it with polygons too..it improved but not much.
And here’s what I’m working on right now..bought my own stuff so this one is Hot Sauce
and also bought nRF24L01+ modules with P.A and LNA and antenna attachments and a display..got my own code already working pretty good with enhanced shock burst feature..which is automatic retransmit if packet loss..quite cool..and joysticks of course. Gotta make our very own Remote control plus points would be..when receiver acknowledges the data received it can also attach a payload..which can be gps data and altitude and stuff.